VLT
®
2800 Series
Introduction to VLT
2800
■ RFI 1B filter
All frequency converters will ca use electromagnetic
noise in the mains supply when they are operating.
An RFI (Radio Frequency Interference) filter will reduce
theelectromagneticnoiseinthemainssupply.
Without an RFI filter there is a risk that a frequency
converter will disrupt other electrical components
that are connected to the mains and might
thus cause operating disruption.
By fitting an RFI 1B filter m od u le between the mains
supply and the VLT 2800, the VLT 2800 complies
with the EMC norm EN 55011-1B.
NB!:
To comply with EN 55011-1B the RFI 1B
filter module must be fitted together with a
VLT 2800 with integral 1A RFI filter.
Technical data for VLT 2803-2875 RFI 1B filter
Max. cable length (screened/armoured) 200-240 V 100 m (At 1A: 100 m)
Max. cable length (screened/armoured) 380-480 V 25 m (At 1A: 50 m)
Enclosure IP 20
Max. rated current 16 A
Max. Voltage 480 V AC
Max. voltage to earth 300 V AC
Min. distance between VLT and RFI 1B filter Side-by-Side
Min. distance above and below RFI 1B filter 100 mm
Dimensions H x W x D (mm)
1)
200 x 60 x 87
Weight 0.9 kg
1)
For mechanical dimensions see under
Mechanical d im e nsions.
See o rd eri n g number for RFI 1B filter module
under Accessories for VLT 2800.
MG.28.E9.02 - VLT is a registered Danfoss trademark
13
To Next Page
Loading...
Need help?
General
