Dantherm CDP 85 - Symbols Used in the Operating Instructions

Introduction: Symbols used in the operating instructions
Hazard symbols
In these operating instructions, particularly important text passages are highlighted
with signal words and symbols that are described below.
...indicates a hazard which, if not avoided, will result in death or serious injury.
...indicates a hazard which, if not avoided, could result in death or serious injury.
...information marked with this symbol helps you to carry out your tasks quickly and safely.
...indicates important information (e.g. property damage) but does not indicate hazards.
...indicates a hazard which, if not avoided, could result in a minor or moderate injury.
CAUTION
INFORMATION
NOTE
WARNING
DANGER
This symbol is used to warn you of potential risk of injuries. Follow all safety instructions indicated in
the manual next to the warning triangle to avoid potential injury or death.
Electrical voltage
This symbol indicates that there are dangers to the life and health of persons due to electrical voltage
when handling the system.
Protective gloves
This symbol indicates that it is required to wear protective gloves when performing a specic operati-
on.
Protective mask
This symbol indicates that it is required to wear a protective mask when performing a specic operati-
on.
Disconnect from mains
This symbol indicates that the plug of the unit should be pulled/disconnected from the mains.
en
Symbols used in the operating instructions
5