Data Aire DAP III - Page 16

16
10-17 Specify sensor 3 maximum value
10-18 Set sensor 3 calibrations
10-19 Select sensor 4 name
10-20 Specify sensor 4 units of measure
10-21 Specify sensor 4 signal range
10-22 Specify sensor 4 minimum value
10-23 Specify sensor 4 maximum value
10-24 Set sensor 4 calibration
10-25 Select output 1 confi guration
10-26 Select output 2 confi guration
Group 11 - Zone Control
11-1 Zone mast enable
11-2 Zone ID
11-3 Unit IDs in this zone
11-4 Primary unit status
11-5 Secondary unit status
11-6 Zone override request
11-7 Unit rotation day
11-8 Unit rotation time
11-9 Standby alarms
11-10 Off alarm
11-11 Temperature standby
11-12 Zone inhibits
11-13 Secondary schedule
11-14 Secondary schedule start day
11-15 Secondary schedule start time
11-16 Secondary schedule stop day
11-17 Secondary schedule stop time