DataCard CD800 Installation And Administrator's Guide

48 Printer Manager
 IPv6ManualAddress—Enter the IPv6 address using the following format:
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
Refer to “Access Printer Manager” on page 38 for more information about entering an IPv6
address.
IPV6ManualSelect must be set to Enabled for the printer to use this setting.
 IPv6ManualPrefixLength—Specify the IPv6 manual subnet prefix length. IPv6 addresses
consist of two parts. The prefix length indicates the boundary between the subnet to which
the host is connected and the device ID in the IPv6 manual address, starting from the left
end. The default value is 64.
 IPv6ManualSelect—Enable the printer to use the manual address specified in
IPv6ManualAddress. If this setting is disabled, the manual address information specified for
the printer is retained, but is not used.
 IPv6StatelessAddrSelect—Enable the printer to allow the router to provide one or more
network prefixes used for stateless automatic address configuration (SLAAC).
To modify the Communications settings:
1. Enter your changes in the Current Value fields.
2. Click Set Current to apply the changes.
3. Log out of Printer Manager, and then restart it for the changes to take effect.

DataCard CD800 Specifications

General

Print Resolution	300 dpi
Weight	12 lbs (5.4 kg)
Power Requirements	100-240 VAC, 50/60 Hz
Print Technology	Dye-sublimation
Card Capacity	100 cards (standard hopper)
Connectivity	USB
Card Size	CR80 (85.6 mm x 54 mm)
Operating System Compatibility	Windows
Card Thickness	0.020" - 0.040" (0.51 mm - 1.02 mm)