60 Printer Manager
TrailTrim—Modify the number of millimeters to remove from the trailing edge of a full-size
image to keep it within the print area (1 mm = 0.0394 in. or about 11.8 dot rows).
Increase the value to lengthen the printed area.
Decrease the value to shorten the printed area.
TWhiteShade—Modify the amount of power applied to the printhead to reduce ribbon
friction without transferring material. Decrease the value if material transfers to the card
when it should not.
VerticalOffset—Modify the image placement on the card. Use this setting to align printing
with the long edges of the card. Specify the number of printhead dots to shift printing toward
the top or left side of the card. You cannot change the number of dots between the long
edges of the card.
YMCPower—Modify the intensity of the YMC (color) ribbon panels.
Increase the value to make the color printing more intense.
Decrease the value to reduce the color intensity or to prevent frequent ribbon breaks
when printing colors.
YMCPower600—Modify the print intensity at 600 dpi for the YMC (color) ribbon panels.
Increase the value to make the color printing more intense.
Decrease the value to reduce the color intensity or to prevent frequent ribbon breaks
when printing colors.
YMCPowerDuplex—Modify the intensity of the back-side YMC (color) ribbon panels.
Increase the value to make the color printing more intense.
Decrease the value to reduce the color intensity or to prevent frequent ribbon breaks
when printing colors.
YMCPowerNosRGB—Modify the intensity when you are printing without the sRGB color
mode.
Increase the value to make the non-sRGB color darker
Decrease the value if using non-sRGB color mode to prevent overly dark printing or
ribbon wrinkles or tears.
YMCWhiteShade—Modify the amount of power applied to the printhead to reduce ribbon
friction without transferring material. Decrease the value if unprinted or white areas of the
card have color applied to them and should not.
To Next Page
Loading...
