DataCard SD460 - Page 105

SD Series Installation and Administrator’s Guide A-5
2.
Carefullytipthelaminator
ontoitsleftside(theside
withouttheaccessdoor).
3. InserttheM6wellnut
threadedinsertsintothe
bolt‐downopeningsonthe
bottomofthelaminator.
4. Returnthelaminatortoits
uprightpositionand
positionitovertheholes
thataredrilledinthe
mountingsurface.
5. Securethelaminatorto
themountingsurface.
A. Placeaflatwasheron
eachofthescrews
beneaththemounting
surface.
B. InserttheM6screws
throughtheholesin
themountingsurface
andintothewellnuts
inthebottomofthe
laminator.
C. Tightenthescrews
securely.