DataCard SD460 - Site Requirements

SD Series Installation and Administrator’s Guide 3
Site Requirements
Setupandusetheprinterinan
environmentthatmeetsthe
followingrequirements.
• Providespacefortheprinter
andforclearancearound
theprinter.Theprinter
dimensionsandclearance
areaareshowninthe
followingtable.
• Placetheprinterinanenvironmentwithtemperaturesrangingfrom60°to
95°F(15°to35°C).
• Useasingle‐phase,3‐wire,groundedreceptacle.
• Placethesystemanditssuppliesinacleanofficeenvironment,keepingpaper
andforeignmaterialsoffoftheequipment.
• Placetheprinteronasturdy,levelsurface.
• Placetheprinterawayfromdirectsunlight.
• Donotplacetheprinternearheatingducts,fans,orotherairvents.
• Donotusetheprinterforpurposesotherthantheintendeduse.
Printer
Model
Dimensions (inches/mm)
ABCDE FG
SD260 10.00
254
8.80
224
4.00
102
6.85
174
4.00
102
15.37
390
4.00
102
SD260L and
SD360
10.00
254
8.80
224
4.00
102
6.85
174
4.00
102
21.21
539
4.00
102
SD460 Refer to Appendix A, "SD460 Site Requirements" on page A-2.
Options such as a large output hopper and 200-card input hopper add height to the
printer. Additional clearance is required when using these options.