DataCard SD460 - Page 57

SD Series Installation and Administrator’s Guide 49
•
KPower1200DPI—Modifytheprintintensityat1200dpifortheKpanelor
Kribbon.
• Increasethevaluetomakesingle‐colorprintingthickerandmoredefined
onthecard.
• Decreasethevalueforcrispbarcodesortopreventfrequentribbon
breakswhenprintingwiththeKpanel.
• KPower600DPI—Modifytheprintintensityat600dpifortheKpanelor
Kribbon.
• Increasethevaluetomakesingle‐colorprintingthickerandmoredefined
onthecard.
• Decreasethevalueforcrispbarcodesortopreventfrequentribbon
breakswhenprintingwiththeKpanel.
• KPowerDuplex—Modifytheprintintensityfortheback‐sideKpaneland
Kribbons.
• Increasethevaluetomakesingle‐colorprintingthickerandmoredefined
onthecard.
• Decreasethevalueforcrispbarcodesortopreventfrequentribbon
breakswhenprintingwiththeKpanel.
• KWhiteShade—Modifytheamountofpowerappliedtotheprintheadto
reduceribbonfrictionwithouttransferringmaterial.Decreasethevalueif
materialtransfers tothecardwhenitshouldnot.
• LeadTrim—Modifythenumberofmillimeterstoremovefromtheleading
edgeofafull‐sizeimagetokeepitwithintheprintarea(1mm=0.0394in.or
about11.8dotrows).
• SettingsGroupPurpose—Statethepurposeofasettingsgroup.Groupnames
arenotchangeable.Usethisoptiontoidentifythereasonforcreatinga
settingsgroup.
• TPower—ModifytheintensityoftheT(topcoat)ribbonpanel.
• Increasethevaluetomakeprintedtopcoatthickerormoreuniform.
• Decreasethevaluetopreventfrequentribbonbreakswhileprintingthe
topcoat.