DataCard SD460 - Page 67

SD Series Installation and Administrator’s Guide 59
•
ExceptionCardDebowDistanceUp—Settheamount(distance)tomovethe
debowarmsup.Thevalueisinincrementsofthedebowmotor.(Thisvalueis
usedwhenExceptionCardDebowDirectionissettoUp.)
• Increasethevaluetobendthecardupmore.
• Decreasethevaluetobendthecardupless.
• ExceptionCardDebowDwellMs—Setthetime,inmilliseconds,thedebow
actionisappliedtoacard.Thedefaultis2000ms(2seconds).
• Increasethevaluetoapplythedebowactionlonger.
• Decreasethevaluetoapplythedebowactionforlesstime.
ExceptionCardImpresserSettings:
• ExceptionCardImpressDepth—Setthedepthoftheimpressiononacard.The
valueisinstepsoftheimpresserpunch.
• Increasethevaluetodeepentheimpression.
• Decreasethevaluetolessentheimpression.
• ExceptionCardImpressDwellTime—Setthetime,inmilliseconds,the
impresserremainsincontactwiththecard.Thedefaultis2000ms
(2 seconds).
• Increasethevaluetoallowtheimpressertoremainonthecardlonger.
• Decreasethevaluetoimpressthecardforashortertime.
• ExceptionCardImpressPositionOffset1—Setthedistancefromthebackedge
ofthecardtothecenterofthefirstimpressiononthecard.
• Increasetheoffsetvaluetoincreasethedistanceoftheimpressionfrom
thebackedgeofthecard.
• Decreasetheoffsetvaluetodecreasethedistanceoftheimpressionfrom
thebackedgeofthecard.
Youmayneedtoadjustthecardimpressdepthvaluebasedonthecard
materialandoverlaytypeused.