DataCard SD460 - Page 90

To Next Page

To Previous Page

82 Supplies and Parts

Thefollowinglaminatorsuppliesareavailable.Allareavailableforafullcard,

smartcard,ormagneticstripecard.

Patch:

• ClearDuraGard,0.5mil,upto350images/roll

• ClearDuraGard,1.0mil,upto300images/roll

• HolographicDuraGard0.6mil,Random,upto350images/roll

• HolographicDuraGard,Registered,0.6mi l,upto350images/roll

• HolographicDuraGard,1.0mil,Random,upto300images/roll

• HolographicDuraGardRegistered,1.0mi l,upto300images/roll

Topcoat:

• Clear,numberofimagesdependsonlaminationsettings

• Holographic,Random,numberofimagesdependsonlaminationsettings

• RegisteredHolographic,upto600images/roll

• *ClearDuraShield,numberofimagesdependsonlaminationsettings

*DuraShieldoverlayhasthefollowingrequirements:

• Itmustbeusedwitharibbonthatincludesatopcoatpanel:KT,

YMCKT,YMCKT‐K,YMCKT‐KT,ymcKT,YMCKF‐KT.

Note:IfyouuseaYMCKF‐KTribbon,refertotheprinter’sDriverGuide

forinformationaboutsettingupacarddesignthat

usestheUV(F)

panel.

• Itmustbeappliedoverthetopcoat.

• ItissupportedonlywithPVCcompositecards.

Other manuals for DataCard SD460