Datakom D-200 MK2 User Manual

D-200 MK2 User Manual Firmware V-6.3
L058D01-EN - 103 -
Related parameters are:
Parameter Definition
Factory Set
Description
Network IP Address
0.0.0.0
This is the IPv4 (internet protocol version 4) address
that the unit will require from the DHCP (dynamic host
control protocol) server.
If this parameter is set to 0.0.0.0 then the unit will
require any IPv4 address from the DHCP server.
If you are not an IP professional please leave this
address as “0.0.0.0”.
Gateway IP Address
0.0.0.0
This is the router IPv4 address, If the Network IP
address and Gateway IP Address are set to “0.0.0.0”
then the unit will get the gateway address
automatically.
If you are not an IP professional please leave this
address as “0.0.0.0”.
Subnet Mask
255.255.255.0
Reserved for IP professionals.
If you are not an IP professional please leave this
address as “255.255.255.0”.
Modbus TCP/IP Port
502
Internal Modbus TCP/IP server’s port number. The unit
answers Modbus requests to this port only.
Modbus Address
1
This is the modbus controller identity used in Modbus
communication.
The ethernet connection status is monitored at ethernet screen page.
17. ETHERNET CONFIGURATION
Connection
status
indicator
IP address
of the unit,
assigned by
the network
switch
Data Receive
and Transmit
Indicators

Datakom D-200 MK2 Specifications

General

Brand	Datakom
Model	D-200 MK2
Category	Controller
Language	English