Datakom D-200 MK2 User Manual

D-200 MK2 User Manual Firmware V-6.3
L058D01-EN - 68 -
The program mode is used to adjust timers, operational limits and the configuration of the unit.
Although a free PC program is provided for programming, every parameter may be modified through the front
panel, regardless of the operating mode.
When modified, program parameters are automatically recorded into a non-erasable memory and take effect
immediately.
The program mode will not affect the operation of the unit. Thus programs may be modified anytime, even
while the genset is running.
In order to resume to the factory set parameter values:
-hold pressed the STOP, LAMP TEST and ALARM MUTE buttons for 5 seconds,
-“RETURN TO FACTORY SET” will be displayed
-immediately press and hold pressed LAMP TEST button for 5 seconds
-factory set values will be reprogrammed to the parameter memory. “Completed!” is displayed.
Hold pressed pushbuttons
Hold pressed
15.1. RESETTING TO FACTORY DEFAULTS
15. PROGRAMMING
Hold
Pressed
For 5
seconds

Datakom D-200 MK2 Specifications

General

Brand	Datakom
Model	D-200 MK2
Category	Controller
Language	English