Datakom D-200 MK2 - 24. SMS COMMANDS

D-200 MK2 User Manual Firmware V-6.3
L058D01-EN - 115 -
COMMAND
DESCRIPTION
ANSWER
GET IP
If GPRS connection is
active, the controller will
reply by an SMS message
indicating the IP address of
the GSM modem.
GPRS 1
Activates the GPRS
connection
GPRS 0
Stops the GPRS connection
RESET
ALARMS
Clears alarms of the controller.
The operating mode is not
modified.
REBOOT
Performs a hard reset on the
controller
no answer
MODEM RESET
Performs a hard reset on the
modem
no answer
GET INFO
Returns the alarm list and
actual measured values
ALARMS (if exists)
GEN: Vavg/ıAVG/kWtot/pf/Freq
MAINS: Vavg/ıAVG/kWtot
OIL_PR/TEMP/FUEL%
SMS messages must be written exactly as below, without any preceding blanks.
Only UPPERCASE characters are permitted.
SMS messages are accepted only from phone numbers recorded in the
Communication>GSM>Message Numbers tab.
Answers to SMS messages will be sent to all phone numbers in the list.
Alarms cleared!
GPRS disabled!
GPRS enabled!
IP: 188.41.10.244
24. SMS COMMANDS