D-500 User Manual Rev_06 Firmware V-5.8
K35D05-EN - 8 -
14.5. WARNINGS
14.6. NON-VISUAL WARNINGS
15. PROGRAMMING
15.1. RESETTING TO FACTORY DEFAULTS
15.2. ENTERING THE PROGRAMMING MODE
15.3. NAVIGATING BETWEEN MENUS
15.4. MODIFYING PARAMETER VALUE
15.5. PROGRAMMING MODE EXIT
16. PROGRAM PARAMETER LIST
16.1. CONTROLLER CONFIGURATION GROUP
16.2. ELECTRICAL PARAMETERS GROUP
16.3. ENGINE PARAMETERS GROUP
16.4. ADJUST DATE AND TIME
16.5. WEEKLY OPERATION SCHEDULE
16.6. EXERCISER SCHEDULE
16.7. SENDER CONFIGURATION
16.8. DIGITAL INPUT CONFIGURATION
16.9. OUTPUT CONFIGURATION
16.10. SITE ID STRING
16.11. ENGINE SERIAL NUMBER
16.12. MODEM1-2/SMS1-2-3-4 TELEPHONE NUMBERS
16.13. GSM MODEM PARAMETERS
16.14. ETHERNET PARAMETERS
16.15. SNTP PARAMETERS
16.16. SYNCHRONIZATION PARAMETERS
17. CRANK CUTTING
18. OVERCURRENT PROTECTION (IDMT)
19. MOTORIZED CIRCUIT BREAKER CONTROL
20. J1939 CANBUS ENGINE SUPPORT
21. GPS SUPPORT
22. ETHERNET CONFIGURATION
23. GSM CONFIGURATION
24. DYNAMIC DNS FEATURE
25. ACCESSING THE EMBEDDED WEB SERVER
26. WEB MONITORING AND CONTROL OF GENSETS
27. CENTRAL MONITORING OF GENSETS
28. E-MAIL SENDING
29. SMS COMMANDS
To Next Page
Loading...
Need help?
General
