DPR-400 User Manual Rev_01 Firmware V-1.0
- 5 -
▪ Electrical equipment should only be installed by a qualified
specialist. No responsibility is assured by the manufacturer or
any of its subsidiaries for any consequences resulting from the
non-compliance to these instructions.
▪ Check the unit for cracks and damages due to transportation.
Do not install damaged equipment.
▪ Do not open the unit. There are no serviceable parts inside.
▪ Fuses must be connected to the power supply and phase
voltage inputs, in close proximity of the unit.
▪ Fuses must be of fast type (FF) with a maximum rating of 6A.
▪ Disconnect all power before working on the equipment.
▪ When the unit is connected to the network, do not touch the
terminals.
▪ Short circuit terminals of unused current transformers.
▪ Any electrical parameter applied to the device must be in the
range specified in the user manual. Although the unit is
designed with a wide safety margin, over-range parameters may
reduce lifetime, alter operation precision or even damage the
unit.
▪ Do not try to clean the device with solvent or the like. Only
clean with a damp cloth.
▪ Verify correct terminal connections before applying power.
▪ Only for front panel mounting.
SAFETY NOTICE
Failure to follow below instructions will result in
death or serious injury.
To Next Page
Loading...
Need help?
General
