INTRODUCTION
2
2.1.1 Indicators
The five LEDs on the side of the scanner (
Figure A, 3) indicate the following:
READY
(green)
This LED indicates the device is ready to operate.
GOOD
(green)
This LED confirms successful reading.
TRIGGER
(yellow)
This LED indicates the status of the reading phase.
COM
(yellow)
This LED indicates active communication on main serial port. *
STATUS
(red)
This LED indicates a NO READ result.
* When connected to a Fieldbus network through the CBX500, the COM LED is always active, even in the
absence of data transmission, because of polling activity on the Fieldbus network.
During the reader startup (reset or restart phase), all the LEDs blink for one second.
On the back of the reader near the cable, the “POWER ON” LED indicates the laser scanner
is correctly powered.
2.2 ID-NET™
The ID-NET™ network is a built-in high-speed interface dedicated
for high-speed scanner interconnection. ID-NET™ is in addition to
the Main and Auxiliary serial interfaces.
The following network configurations are available:
ID-NET™ M/S Synchronized: Single station – multiple scanners
CBX100
CBX100
CBX100
ID-NET™ interface allows local connection of multiple scanners reading different sides of the
same target. All scanners share a single presence sensor and activate/deactivate
simultaneously.
At the end of each reading phase a single data message is transmitted to the host.
Thanks to ID-NET™, data communication among scanners is highly efficient so that an
immediate result will be available.
19
To Next Page
Loading...
Need help?
General
