DS4800 REFERENCE MANUAL
6
Alternatively, the Master scanner can communicate to the Host as a Slave node on a
Fieldbus network. This requires using an accessory Fieldbus interface board installed inside
the CBX500 connection box.
System configuration can be accomplished through the Auxiliary interface of the Master
scanner (internal CBX500 9-pin connector) using the Genius™ configuration program or
Genius™ based Host Mode programming.
3
Power
Slave#1 Slave#n
2
Master
1
Host
Fieldbus Interface
External Trigger (for On-Line Mode)
ID-NET™ (up to 16 devices - practical limit)
Figure 74 – ID-NET™ Fieldbus M/S Synchronized Layout
4
Power
Master Slave#1 Slave#n
2
Terminal
3
1
Fieldbus Interface
Auxiliary Serial Interface (Local Echo) (RS232)
External Trigger (for On-Line Mode)
ID-NET™ (up to 32 devices, max network extension of 1000 m)
Host
Figure 75 – ID-NET™ Fieldbus M/S Multidata
74
To Next Page
Loading...
Need help?
General
