Datalogic GBT4100 - Programming Mode

LED and Beeper Indications
38 Gryphon™ I GBT4100
Reader Active
Mode
The reader is
active and ready
to scan.
The LED is lit
steadily
a
N/A
Reader
Disabled
The reader has
been disabled by
the host.
The LED blinks
continuously
N/A
Green Spot is
on continu-
ously
While in Stand
Mode or Trigger
Stand Mode the
green spot shall
be on while in
stand watch
state.
N/A N/A
Green Spot
a
flashes
momentarily
Upon success-
ful read of a
label, the soft-
ware shall turn
the green spot
on for the time
specified by the
configured
value.
N/A N/A
Programming Mode - The following indications ONLY occur
when the reader is in Programming Mode.
Label Program-
ming Mode
Entry
A valid program-
ming label has
been scanned.
LED blinks
continuously
Reader sounds
four low fre-
quency beeps.
Label Program-
ming Mode
Rejection of
Label
A label has been
rejected.
N/A
Reader sounds
three times at
lowest fre-
quency and cur-
rent volume.
INDICATION
DESCRIPTIO
N
LED BEEPER