Scale Features
Product Reference Guide 6-53
Scale Warm-up Time
Specifies the amount of time after entering scale warm-up mode before
the scale enters scale-active mode.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan your selection from the bar codes below.
3. You’ll need to cover any unused bar codes on this and the facing
page to ensure that the scanner reads only the bar code you intend
to scan.
4. Complete the programming sequence by scanning the SWITCH
bar code.
SCALE WARM-UP TIME = NO WARM-UP
SCALE WARM-UP TIME = 5 SECONDS
NOTE
Applies only when Scale Enable is enabled.
To Next Page
Loading...
