6-122 Magellan
®
8300/8400
RS-232 ICL DC1 Character Delay Enable
Enables/disables the ability of the scanner to delay a DC1 response for 40
milliseconds.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code below which represents the desired setting for this
feature. You’ll need to cover any unused bar codes on this and the
facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
RS-232 ICL DC1 CHARACTER DELAY = DISABLE
RS-232 ICL DC1 CHARACTER DELAY = ENABLE
To Next Page
Loading...
