Safety and Regulatory Information
160 Memor™ 10
CAUTION
This device has been tested and found to comply with the
limits pursuant to EN 303417. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular istallation.
If this equipment causes harmful interference to other
electronic equipments, which can be determined by turning
the equipment OFF and ON, the user is encouraged to
correct the interference with one or more of the following
measures:
• Reorient or relocate the equipment
• Increase the distance
To prevent the temperature from getting too high, don't
place any metal objects between the TX surface and the RX
surface.
To Next Page
Loading...
