1 MEMOR™ X3
2 BATTERIES AND MAINTENANCE
Rechargeable backup batteries and battery packs are not initially
fully charged. Therefore the initial operation to perform is to charge
them. See below.
NOTE
By default, the main battery pack is disconnected at the factory to
avoid damage due to excessive draining.
NOTE
Annual replacement of rechargeable battery pack avoids possible
risks or abnormalities and ensures maximum performance.
CAUTION
2.1 CHARGING THE BATTERY PACK
The battery pack autonomy varies according to many factors, such
as the frequency of barcode scanning, RF usage, battery life,
storage, environmental conditions, etc.
The battery icon on the Taskbar indicates when the battery pack is low.
It is possible to recharge the battery pack by connecting the power supply directly to
the Memor X3.
Alternatively, it is also possible to recharge the battery pack by inserting the Memor
X3 into the single slot dock or into the four slot dock.
During the charging process the LED positioned at the right side of the display glows
red constantly. Once the charging process has been completed this LED glows green
constantly (see par. 4.4).
The stand alone battery pack may be recharged outside a Memor X3 using the spare
battery charging slot on the back of the single slot dock or the multi battery charger.
To Next Page
Loading...
Need help?
General
