Datalogic Memor X3 User Manual

1 MEMOR™ X3
66
4
4. Carefully press and briefly hold stylus on the center of the target. Repeat as the
target moves around the screen. Press the Esc key to cancel the stylus
calibration:
5. Press the Enter key or tap the screen to accept the new calibration settings.
Press the Esc key to keep the old settings.
New calibration settings are persistently saved in the Registry.
Startup Stylus Calibration
When starting the terminal, a stylus calibration screen comes up if valid calibration
settings are not available. This happens in the following circumstances:
1. At the first startup of the terminal.
2. After restoring registry default settings using the applet Registry Admin and
performing a warm boot.
3. After a Clean Boot.
4. After a Firmware Update (see section 4.8.3)

Datalogic Memor X3 Specifications

General

Display Size	2.4 inches
RAM	256 MB
Processor	XScale PXA310 @ 806 MHz
Storage	512 MB
Operating System	Windows CE 6.0
Battery Capacity	1430 mAh
Connectivity	Wi-Fi, Bluetooth v2.1
Scanner	2D Imager
Battery Options	Standard and High Capacity
Protection	IP54
Drop Specification	Withstands drops from 1.2 meters
Operating Temperature	-10 to 50 °C
Storage Temperature	-20 to 70 °C