Data Editing
122 PowerScan
TM
PD7100 Corded
conversion: BB22BB22.
The A characters were converted to B characters and the 1 characters were converted to
2 characters. Nothing is done with the last two character pairs, since they are all FF.
To set Character Conversion:
1. Scan the ENTER/EXIT barcode.
2. Scan the “Configure Character Conversion” barcode.
3. Determine the desired string. Sixteen positions must be determined as in the above
example. Next, turn to the ASCII Chart on the inside back cover of this manual
and find the equivalent hex digits needed to fulfill the string.
4. Turn to Appendix E, Keypad and scan the barcodes representing the hex charac-
ters determined in the previous step.
5. Scan the ENTER/EXIT barcode to exit Programming Mode.
Character Conversion — continued
NOTE
If less than the expected string of 16 characters are selected, scan
the ENTER/EXIT barcode twice to accept the selections and exit Pro-
gramming Mode.
ENTER/EXIT PROGRAMMING MODE
Configure Character Conversion
DEFAULT
0xFFFFFFFFFFFFFFFF
(No character conversion)
To Next Page
Loading...
Need help?
General
