Datalogic Powerscan PD7100 - Send Control Characters

Keyboard Interface
76 PowerScan
TM
PD7100 Corded
Send Control Characters
This feature Specifies how the reader transmits ASCII control characters to the host. Ref-
erence Appendix F, Scancode Tables for more information about control characters.
Options are as follows:
Control Character 00 — Characters from 00 to 0x1F are sent as control character
Ctrl+Keys, special keys are located from 0x80 to 0xA1.
Control Character 01 — Characters from 00 to 0x1F are sent as control character
Ctrl+Capital Key, special keys are located from 0x80 to 0xA1.
Control Character 02 — Special keys are located from 00 to 0x1F and characters from
0x80 to 0xFE are intended as an extended ASCII table (Microsoft Windows Codepage
1252 — see Microsoft Windows Codepage 1252 on page 376).
ENTER/EXIT PROGRAMMING MODE
Wedge Send Control Characters = 00
Wedge Send Control Characters = 01
Wedge Send Control Characters = 02
DEFAULT