Datalogic PowerScan PM9500

Enter/Exit Programming Mode
Product Reference Guide 221
Date-Time Separator
Sets the character used to separate Date and Time from the next field in
message.
DEFAULT
$CRFTD0000\r
Disable Date-Time Separator
$CRFTD01\r
Set Character Separator =
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left follow
ed by 2 digits from the Alphanumeric characters
in
Appendix D, Keypad representing your desired
character(s). End by scanning the ENTER/EXIT bar code
again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL