Enter/Exit Programming Mode
Product Reference Guide
235
PM9500-ONLY FEATURES
The features in this section are valid only for the PowerScan PM9500 Star
model:
•
STAR Radio Protocol Timeout on page 235
• STAR Radio Transmit Mode on page 236
STAR Radio Protocol Timeout
This parameter sets the valid wait time before transmission between the
handheld reader and Base Station is considered failed.
When setting this parameter, take into consideration the radio traffic (num-
ber of readers in the same area). The selectable range for this feature is
from 02 t
o 25 seconds. See
page 289 in “References” for detailed informa-
tion and examples for setting this feature.
Set Radio Protocol Timeout
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by two digits from the Alpha-
numeric characters in
Appendix D, Keypad
rep-
resenting your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Ma
ke a mistake? Scan the CANCEL barcode to abort
and not
sav
e the entry string. You can then start
again at the beginning.