Datalogic PowerScan PM9500

Enter/Exit Programming Mode
Product Reference Guide 237
Changing System Speed
1. Link the PM9500 with a BC9xxx Base.
2. With the PM9500, read a “Compatib
le Mode/Normal Mode Speed” pro-
gramming label on
page 238 to set “Low, Medium, or High Speed”.
3. Place the PM9500 into the BC9xxx.
The Reader and Base will now be linked at the new programmed speed.
This feature can also be progra
mmed using Datalogic Aladdin.
1. On the BC9xxx Base, change the Compatible mode
parameter to low,
intermediate, or high speed through Aladdin.
2. Place an unlinked PM9500 onto the BC9xxx base.
The Reader and base will link at the new programmed speed.