Datalogic PowerScan PM9500

Enter/Exit Programming Mode
250 PowerScan™ PD9530/PBT9500/PM9500
Action Configuration for Function Keys
Configure actions (up to three) for the function keys
Configure Actions for F1
DEFAULT
$CPWEV0000\r
F1 No Actions Configured
$CPWEV
Configures Action for F1
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
for the Function Key
you want to program. Next scan
4 digits from the Alphanumeric characters in
Appen-
dix D, Keypad
.
The first digit must be 0; the following 3 digits must
be configured accordi
ng to the CMD_ID numbers in
Table 26 on page 249 . End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
DEFAULT
$CPWET0000\r
F2 No Actions Configured
$CPWET
Configure Actions for F2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
for the Function Key
you want to program. Next scan
4 digits from the Alphanumeric characters in
Appen-
dix D, Keypad
.
The first digit must be 0; the following 3 digits must
be configured accordi
ng to the CMD_ID numbers in
Table 26 on page 249 . End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
Configure Actions for F2