Set String Terminator
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left
followed by 32 digits from the Alphanumeric
characters in
Appendix D, Keypad.
The digits must be the hexadecimal ASCII representa-
tion of the desired characters. If less than the
expect
ed string of 16 characters are selected, scan the
ENTER/EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning the
ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to
abort
and not save the entry string. You can then start
again at the beginning.
To Next Page
Loading...
