REFERENCES
143
4.8 CONFIGURATION EDITING COMMANDS
The following commands carry out their specific function and then exit the
configuration environment.
Command Description
Ì$+$*oÎ
Restore the reader default configuration (see the
relative Quick Reference Manual for default
settings)
Ì$+$!KÎ
Transmit the reader Software release
Ì$+$&_Î
Transmit the reader configuration in ASCII
format.
This command is not effective with Pen
emulation interface or with the reader model.
Ì$+RX0$-qÎ
Restore the cradle default configuration (see the
relative Quick Reference Manual for default
settings)
Ì$+RX1$-vÎ
Transmit the cradle Software release.
Ì$+RX2$-{Î
Transmit the cradle configuration in ASCII
format.
This command is not effective with Pen
emulation interface.
To Next Page
Loading...
