CONFIGURATION
9
3 CONFIGURATION
3.1 CONFIGURATION METHODS
3.1.1 Reading Configuration Barcodes
This manual can be used for complete setup and configuration of your reader by
following the setup procedures in this chapter.
If you wish to change the default settings, this manual provides complete
configuration of your reader in an easy way.
To configure your reader:
1. Open the folded page in Appendix
C with the hex-numeric table and keep it open
during the device configuration.
2. Read the Enter Configuration code ONCE
, available at the top of each page of
configuration.
3. Modify the desired parameters in one or more sections following the procedures
given for each group.
4. Read the Exit and Save Configuration code ONCE, available at the top of each
page of configuration.
Reference notes describing the operation of the more complex parameters are given
in chapter 4.
3.1.2 Datalogic Aladdin™
Datalogic Aladdin™ is a multi-platform utility program that allows device configuration
using a PC. It provides RS-232 interface configuration as well as configuration
barcode printing.
3.1.3 Copy Command
A previously configured device (Master), can be used to send its configuration directly to
other devices of the same type (Slaves). The particular procedure for each device is
given.
To Next Page
Loading...
Need help?
General
