SETTINGS
USER’S MANUAL
43
Label Suffix
Tap Label suffix to enter the characters you will be using as suffix. Tap Add special to
select a special character to be added in the current cursor position:
Group Separator Replacement
The Group Separator replacement is a non printable data separator character (ASCII
code 1D hex). Tap Group Separator replacement to enter a string that will be used as
GS data separator substituting the standard GS character.
Tap Add special to
select a special character to be added in the current cursor position:
Remove Non-Printable Characters
Enable it to remove non-printable characters from a unicode string.
Send Code ID
Tap Send code ID to add a code identifier prefix or suffix to the barcode string:
The AIM ID (Association for Automatic Identification and Mobility) is an international
barcode identifier. When AIM identifier before is enabled, the AIM ID is inserted at the
beginning of the decoded barcode.
DLM identifier is a Da
ta
logic specific character identifier.
User defined identifier is a user specific char
acter identifier you can set in the related
symbology settings menu.
To Next Page
Loading...
