Datamax Ex2 - Using the Printer Configuration Utility (DMXConfig) to set IP values

6
The 'NIC ADAPTER' section on the
Configuration Label will list the printer's current
network settings.
After 90 seconds if a DHCP server is not found
the printer will fall back to its default network
settings of:
IP Address: 192.168.10.2
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
If the DHCP retrieval was successful, a new IP
address value should be shown. This IP
address can then be used to browse to the
printer's internal web pages for further
configuration or used for installing the Windows
Driver.
Using the Printer Configuration Utility (DMXConfig) to set IP values
1. Connect the printer to the host via the parallel or serial port
2. Start the DMXConfig program, see the Printer Configuration Utility section for installation.
3. Click “Query Printer” Button – This will
retrieve the printer's current configuration.