H-Class 41
Printer Options (continued)
Menu Item Details
PRESENT SENSOR
Controls the Present Sensor or the Peel and Present
option, where:
MODE
Sets the detection method and response of the printer,
where:
DISABLED
Disables the option.
AUTO
Detects, enables, and sets the label stop location for
the sensor option; if not detected, the option will be
ignored.
ENABLED
Enables and sets the label stop location for the option;
if not detected, a fault will be generated.
RETRACT DELAY
Programs a time delay for the retraction of the next
label in the print process, where:
070 (1 – 255 x10mS)
Is the duration, times 10 milliseconds.
CUTTER
Controls the Cutter option, where:
MODE
Sets the detection method and response of the printer,
where:
DISABLED
Disables the option.
AUTO
Detects, enables, and sets the label stop location for
the cutter; if not detected, the option will be ignored.
ENABLED
Enables and sets the label stop location for the cutter;
if not detected, a fault will be generated.
CUT BEHIND
Allows a number of small labels to queue before a cut
is performed, increasing throughput, where:
;
This mode can be used without a cutter to allow
the presentation of an extra label, with retraction
occurring upon the next job or feed operation.
0 (0 – 2)
Is the queue number.
;
After a fault or unknown label position, the leading
edge will be cut to ensure no extra material exists
at the beginning of the first label; otherwise,
cutting will occur only as specified.
To Next Page
Loading...
Need help?
General