EasyManuals Logo

Datamax Mark II User Manual

Datamax Mark II
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
Appendix B – Internal Menu 49
+
Problem Possible Cause Solution
Tear Mode is
selected but the
label stop position
(present position) is
not far enough
forward.
Another present
position has been
determined. Enabling
the Present Sensor
causes the label stop
position (present
position) to be
approximately 0.1”
behind the peel bar.
~OR~
The Present Adjust
value is not correct.
Disable the Present Sensor.
~OR~
Ensure the host computer is not providing a Present Distance
shorter than is required for the Tear Bar.
~OR~
Use the Setup Menu to modify the Present Adjust value.
Tear Mode is
selected but the
label stop position
(present position) is
too far forward.
Another present
position has been
determined.
~OR~
The Present Adjust
value is not correct.
Ensure the host computer is not providing a Present Distance longer
than is required for the Tear Bar.
~OR~
Use the Setup Menu to modify the Present Adjust value.
The Fault Light
illuminates during
label alignment.
The label supply is
empty
Load media.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datamax Mark II and is the answer not in the manual?

Datamax Mark II Specifications

General IconGeneral
Print MethodThermal Transfer/Direct Thermal
Resolution203 dpi
Max Print Speed6 ips (152 mm/s)
ConnectivityUSB, Serial, Parallel, Ethernet
Media SensorReflective/Transmissive
Processor32 bit RISC processor
Media TypesLabels, Tags, Tickets
Media Thickness0.002 to 0.010 inches
Power Source100-240V AC, 47-63 Hz
Ribbon Width1.0 to 4.25 inches

Related product manuals