EasyManuals Logo

Datamax Mark II User Manual

Datamax Mark II
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
Appendix B – Internal Menu 45
B.2.3 Step by Step Modification of the Printer Setup
The following is an example of Printer Setup modification. Although this example will detail how to modify the
serial Baud Rate, the same method can be used to change any of the printer’s menu item settings.
It is recommended that the Setup Mode not be entered while in Peel Mode or with the optional Present
Sensor enabled; depending on label size, this can cause unpredictable results.
1. With media loaded, press and hold the
F1
Button while powering ON the printer. Continue to hold the
button until the Paused Light turns OFF, and then release the button.
2. Press and hold the
F2
Button and count 9 flashes of the Fault Light, then release it. The following printout
should be produced:
3. Press the
F2
Button one time to increment to the 19200 bps value. The following printout should be
produced:
4. At this point you will accept the current values for test and exit the Printer Setup Procedure by
simultaneously and briefly pressing the
F1
+
F3
Buttons. Wait until the Paused Light goes OFF.
If you wish to discard your changes and revert back to the previous values simply turn OFF power to the
printer before Step 5.
5. Now you can save your changes and resume Normal Mode by simultaneously and briefly pressing the
F1
+
F3
Buttons. Wait until the Paused Light goes OFF.
6. To confirm that your changes have been made press the
F2
+
F3
Buttons simultaneously, this will print the
Database Configuration Label. The label should show the new Baud Rate value of 19200.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datamax Mark II and is the answer not in the manual?

Datamax Mark II Specifications

General IconGeneral
Print MethodThermal Transfer/Direct Thermal
Resolution203 dpi
Max Print Speed6 ips (152 mm/s)
ConnectivityUSB, Serial, Parallel, Ethernet
Media SensorReflective/Transmissive
Processor32 bit RISC processor
Media TypesLabels, Tags, Tickets
Media Thickness0.002 to 0.010 inches
Power Source100-240V AC, 47-63 Hz
Ribbon Width1.0 to 4.25 inches

Related product manuals