Appendix C – Ethernet Setup 59
C
C
C
.
.
.
5
5
5
D
D
D
M
M
M
X
X
X
C
C
C
o
o
o
n
n
n
f
f
f
i
i
i
g
g
g
U
U
U
t
t
t
i
i
i
l
l
l
i
i
i
t
t
t
y
y
y
DMXConfig (located on the Accessories CD-ROM) is a Windows
based configuration utility that allows the
user to make changes to the existing printer setup via a direct connection to the host computers serial and
parallel connection. This is a vital tool for the use and configuration of wired and wireless printer setup.
Be sure to use the DMXConfig utility located on the Accessories CD-ROM that is included with your printer.
Older versions might not operate correctly with some printers. For the latest version please visit our web site
at http://www.datamax-oneil.com
Wired Configuration - Static IP Address:
Note: The following example uses the DMXConfig software utility to configure the printer.
1. Connect the host to the printer with a serial
or parallel cable.
2. Turn ON the printer.
3. Launch the DMXConfig utility. Query the
printer by using the Query Printer toolbar
button (top-left). This will connect to the
printer and get the current printer settings.
4. Next select the Communications tab, scroll
down to the network parameters. Set DHCP
Status to Disable, then set following with
appropriate values for your network:
IP Address
Subnet Mask
Gateway Address
5. Send the settings to the printer using the
Configure Printer toolbar button.
6. The printer will reset and will connect to
your network.
Once the previous steps have been successfully completed you may now use the IP Address to:
> Install a printer driver, and start printing from your Windows
applications; see Section C.6.
-or-
> Browse to the internal web pages for advanced configuration; see Section C.4.
To Next Page
Loading...
Need help?
General
