EasyManuals Logo

Datamax Mark II User Manual

Datamax Mark II
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
44 Appendix B – Internal Menu
21) HEAT
Controls the “burn-time” of the printhead. This is
the equivalent of Heat Setting on most label
software programs.
Possible Values:
Range: 0 – 30; default = *10
22) IMAGING MODE
This command instructs the printer whether to pre-
image the label format:
Possible Values:
* Multiple label (The printer images multiple labels
as memory permits, achieving the
fastest throughput; however, if
time stamping, the time will reflect
the moment the label is imaged
rather than when actually printed.)
Single label (The printer images the next label
only after the previous label has
been successfully printed. Single
processing provides time-stamps
that are more accurate, but it
slows label throughput time.)
23) FAULT HANDLING
When a fault condtions is detected, printing stops
and the
Fault Light illumintes. After the problem is
corrected, the FEED Button must be pressed to
clear the fault. The label in process is not reprinted.
Possible Values:
YES or NO; default = *NO
(NO = NO REPRINT disabled, reprinting will occur.)
24) HEAT COMMANDS
This command causes the printer to ignore DPL
Heat commands; instead, the Heat value is
controlled via the menu setting.
Possible Values:
* ENABLED
DISABLED
25) SPEED COMMANDS
This command causes the printer to ignore DPL
speed commands; instead, speed values are
controlled via the menu setting.
Possible Values:
* ENABLED
DISABLED
The items in the Printer Setup Menu List are stored in non-volatile memory.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datamax Mark II and is the answer not in the manual?

Datamax Mark II Specifications

General IconGeneral
Print MethodThermal Transfer/Direct Thermal
Resolution203 dpi
Max Print Speed6 ips (152 mm/s)
ConnectivityUSB, Serial, Parallel, Ethernet
Media SensorReflective/Transmissive
Processor32 bit RISC processor
Media TypesLabels, Tags, Tickets
Media Thickness0.002 to 0.010 inches
Power Source100-240V AC, 47-63 Hz
Ribbon Width1.0 to 4.25 inches

Related product manuals