Datamax W-6208 - Page 100

90 W-Class
Media and Ribbon Requirements (continued)
E
A
B
C
D
G
H
I
J
F
Media Dimensions
Designator Description
Maximum
[1]
Minimum
[1]
Amedia width:
W-6208 and W-6308
W-8306
6.700
9.000
2.000
3.000
B backing material width:
W-6208 and W-6308
W-8306
6.700
9.000
2.000
3.000
C gap (or notch) between labels
[4]
- .100
D label length
[4]
- 0.500
E media thickness
[2]
.0100 .0025
F width for sensor opening .500 .200
G left justified distance from the edge of
the media to the media aperture
3.250 .200
H reflective mark width
[3]
:
W-6208 and W-6308
W-8306
6.700
9.000
1.000
1.000
I distance between reflective marks
[4]
- .500
J reflective mark length
[4]
- .100
[1]
Units of measure given in inches.
[2]
If the optional Light-Duty Cutter is attached, it must be aligned to only cut material,
where the thickness can be no greater than .006” (.152 mm).
[3]
The reflective (black) mark must be carbon based, placed on the backside of the stock;
the reflectance shall be less than 10% at wavelengths of 950 and 640 nm.
[4]
The maximum allowable length of the combined label and gap (or mark) measurement
cannot exceed 99.99 inches.