Datamax W-6208 - Display Messages; User Prompts and Condition Messages

48 W-Class
4.2 Display Messages
The printer displays several different types of information (if not in the menu
system or Quick Test Mode):
½ User Prompts and Condition Messages (also see Section 4.1.1 for a listing
of the Enter / Exit Prompts)
½ Application and Boot Loader Updating Messages (see Section 5.3 and 5.4)
½ Fault and Warning Messages (see Section 6.1)
4.2.1 User Prompts and Condition Messages
User Prompts alert the operator to a required action. Condition Messages are
used to indicate an operational state.
User Prompts and Condition Messages
Displayed Message Description Condition(s)
CLEARING FAULTS
The printer is trying to
clear a fault condition.
Occurs when the FEED key
is pressed after the
correction of a fault.
CALIBRATING
A media calibration is
being performed.
The FEED key was pressed
and held.
CANCEL PRINT JOB?
ENTER KEY = YES
The CANCEL or
TEST key was pressed
during a batch job.
The current print batch will
be cancelled if ENTER is
pressed; the remaining
labels will not be printed.
PAUSED
The printer is paused
or offline.
The printer is in a paused
condition.
READY
Ready Mode.
Normal operating mode.
The printer is ready to
receive and process label
formats.