Datamax W-6208 - Roll Media

W-Class 13
3.1.1 Roll Media
This loading method is for roll type media applications. To load:
å Slide Roll Media onto the Media
Supply Hub until it rests against the
Backstop.
 Route the media as shown below:
under the Bouncer Assembly, through
the Media Sensor, then out the front
of the printer.
ê Slide the Media Guide over until it
rests lightly against the edge of the
media.
 Position the Media Sensor; see
Section 3.2.
 If your application uses thermal transfer media, load ribbon (see Section
3.3); otherwise continue.
ñ Lower the Printhead Assembly and rotate the Printhead Latch completely
back into the locked position. Close the Access Cover.
ò Turn ‘On’ the printer. After ‘Ready is displayed, press and hold the FEED
key until at least one label gap or mark is advanced; see Section 3.4.
☞
If using less than full width media, adjust the Leveling Cam; see Section
5.1.1.