18 W-Class
3.5 Outputting Labels
In addition to directly outputting labels from the printer, there are several
optional output configurations available.
3.5.1 Rewinding onto the Media Rewind Hub
With the Internal Rewind option, the printed labels and backing material can be
wound directly onto the Media Rewind Hub. To rewind labels and backing:
å Load media as described in
Section 3.1.
Remove the Tear Bar and
install the Arc Plate.
ê Remove the Media Retainer
from the Media Rewind Hub.
Press the FEED key and
advance about 20 inches (51
cm) of media then guide it
onto the Media Rewind Hub, as shown. Place the leading edge of the media
into the Slot in the hub and rotate several times to secure.
Slide the Media Retainer onto the hub so that it rests lightly against the edge
of the media and tighten the Thumbscrew. Close the Access Cover.
To Next Page
Loading...
