W-Class 83
Printer Fault Messages (continued)
Displayed Message Description Possible Solution(s)
TOP OF FORM FAULT
The printer could
not find the TOF
mark within the
maximum label
length setting or it
found a TOF in an
unexpected place.
ã Note: When the
printer is set for
reflective media,
this indication is
given for an out of
stock condition.
If media is moving:
1) Press the FEED key. It may
be necessary to re-calibrate
the printer; see Section 5.0.
2) The Media Sensor may be
out of position. Readjust it;
see Section 3.2.
3) The media may not be
properly loaded. Reload
media, also ensure that the
Media Guide is positioned
properly; see Section 3.1.
4) The Leveling Cam may be
improperly adjusted; see
Section 5.1.1.
5) The label may be longer
than the default value for
maximum length. Check
the Media Settings /
Maximum Label Length;
see Section 4.1.2.
6) The Media Sensor may be
obstructed. Check and
carefully remove any
obstruction (labels, paper
dust, adhesive, etc).
If media is not moving:
The printhead assembly may
not be latched; close and
lock.
To Next Page
Loading...
