1-2
001-4006-101
1.4 ACCESSORIES
For information about sales and accessories, contact your sales representative. In the U.S. phone 1-800-992-
7774 or 1-507-833-8819.
1.4.1 FACTORY MUTUAL NI KIT
The T-96SR with the Factory Mutual NI Kit (part number 023-1000-100) is approved as non-incendive for
Class 1, Groups ABCD, Division 2, hazardous locations by Factory Mutual Research Corporation. This
option includes approval for International Electrotechnical Commission (IEC) Class 1, Zone 2.
Approved models are labeled with this rating. Only units with the Factory Mutual approved label carry the
non-incendive rating. Contact your Dataradio representative for more information concerning your
particular requirements.
Installation, service, and repair of the FM approved units must be in accordance with the instructions found
in this manual and the National Electrical Code (ANSI-NFPA70) Division 2 Hazardous (classified) Location
Incendive Wiring Techniques. Mount the unit in an enclosure or assembly. Route all interconnecting cables
(DC power and coaxial) through conduit as specified in the National Electrical Code document referenced
above. For further guidance on installation, see ANSI/ISA-RPI2.6: Installation of Intrinsically Safe Systems
for Hazardous (Classified) Locations.
Table 1-2 T-96SR Accessories
Accessory DRL Part Number
Unterminated Power Cable 023-3276-007
DE-15 to DB-9 Power and Data Cable 697-0000-001
Field Programming Kit 250-4006-001
Factory Mutual NI Kit 023-1000-100
Installation Manual for T-96SR 001-4006-102 (CD ROM version)
001-4006-101 (Hard Copy version)
DIN Rail Mount 250-4800-406
Switching Power Converter 250-0300-075 (7.5 VDC VOut, 3 Amp)
250-0300-133 (13.3 VDC V Out, 3 Amp)
Figure 1-1 FM Approved External Connections
DC Power (13.3V)
User Interface Cable
To Antenna System
(SMA Connector)
To Next Page
Loading...
