3.
1.
2.
5
188
OK
00
User instruction
Window No. 1
1. Selecting the user
identification number
Before using the equipment, you must assign a user number to every user.
Mother Father Daughter
Son
User 1
User 2 User 3
User 4
The ergo_bike computer will record,
store and evaluate the training data of
up to four users separately.
Guest users, or any persons, whose training data will not be saved, should use
identification number "0". When using this ID number the arrow pointing to
User 1 to 4 will not be displayed. Instead the number "0" is displayed under .
No training data will be saved for the "Guest" user when the ergo_bike
is turned off!
press repeatedly until the
user arrow or the "0"
under Prog starts to flash
reset
00
the user arrow
or
flashes
Either
turn until the flashing
arrow points to
the required user number or until
the "0" under prog flashes
user
once
press
Window No. 1
The settings are confirmed
and saved
User 1 - 4 / Guest 0
Set up of the User identification number 1 to 4
or Guest 0
Window 1
The following is an example of a possible number attribution scheme in a family:
The Dashboard
prog
To Next Page
Loading...
