DCS CT-365SS - Removing a Jet Holder and Jet Holder Simmer

PRELIMINARY
REMOVING A JET HOLDER AND JET HOLDER SIMMER
CAUTION: Make sure that the cooktop compo-
nents are cool before you begin.
1. Turn off the gas and disconnect power to
the cooktop.
2. Remove the cooktop (see page 26 for the
procedure).
3. To remove a jet holder:
a) Remove the 1/2″ gas line fitting.
b) Remove the 1-1/8″ nut and remove the
jet holder from the bracket.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
4. To remove a jet holder simmer:
a) Remove the 3/8″ gas line fitting.
b) Remove the 5/8″ nut and remove the jet
holder simmer from the bracket.
Jet Holder
1/2″ Gas
Line Fitting
Jet Holder
Simmer
3/8″ Gas
Line Fitting
Jet Holder
Jet Holder
Simmer