PRELIMINARY
WARNING: Disconnect power before
servicing
IMPORTANT: Reconnect all grounding
devices
All parts of this appliance capable of
conducting electrical current are
grounded. If grounding wires, screws,
straps, clips, nuts, or washers used to
complete a path to ground are re-
moved for service, they must be re-
turned to their original position and
properly fastened.
TECHNICAL DATA SHEET #17677
IMPORTANT SAFETY NOTICE
This information is intended for use by
persons possessing adequate back-
grounds of electrical, electronic and
mechanical experience. Any attempt to
repair a major appliance may result in
personal injury and property damage.
The manufacturer or seller cannot be
responsible for the interpretation of
this information, nor can it assume any
liability in connection with its use.
GAS SUPPLY REQUIREMENTS
Recommended minimum regulator input
pressures to maximize performance:
Natural Gas-7.0″ W.C. LP Gas-12.0″ W.C.
A pressure tap hole is located on the side of
the regulator to allow checking the manifold
pressure. Remove the 3/16″ Allen Screw plug
and install a 1/8″ NPT nipple to test. Reinstall
the plug and check for leaks.
Gas Type Incoming Pressure Pressure Regulator
To Regulator Output Supplies
Natural 6.0″ to 9.0″ W.C. 4.0″ W.C.
LP 11.0″ to 14.0″ W.C. 10.0″ W.C.
ELECTRONIC IGNITION AND RELIGHT
Surface burners are lighted by electronic igni-
tion, eliminating the need for standing pilot
lights with constantly burning flames.
All the igniters make clicking sounds and spark
even when only a single burner is being turned
on. Do not touch any of the burners when the
igniters are clicking.
The burners on this cooktop relight automati-
cally if the flame goes out. This helps prevent
the inconvenience of having to manually relight
a burner.
Occasionally, the burners may spark if excess
wind or draft blows the flame away from the
burner spark electrode.
All of the burner igniters spark while a burner
is relighting.
This ignition system is not sensitive to reversed
house wiring polarity.
TO REMOVE THE COOKTOP
Cooktop removal is required for:
• Gas piping inspection
• Wiring Service
• Valve replacement
• Jet holder service
• Manifold service
• Indicator light replacement
• Bezel replacement
• Gas conversion
To Next Page
Loading...
