DCS RGSC-305 - Convection Fan; Transformer and Relay Assembly Disconnect Power Supply

PRELIMINARY
22
COMPONENT ACCESS
5. Follow wire through oven wall to connection below.
Remove wire nut (fig.26 and 27).
CONVECTION FAN
1. Follow door removal (fig. 21 and 22). Remove oven
racks and oven floor.
2. Remove the two (2) screws holding the convection
baffle in place.
3.Remove the (4) bolts holding convection cover in place.
Remove cover (fig.28).
4. Remove four 7/16” bolts holding convection motor
assembly (fig 29).
5.Support motor assembly inside oven and remove wire
nuts.
TRANSFORMER AND RELAY ASSEMBLY
1.Disconnect power supply
2.Follow kick panel removal step (fig.23).
3. Removed (2) 5/16”bolts holding transformer bracket.
Disconnect wire harness (fig.30).
4.Remove (2) 5/16”bolts holding the relay bracket.Slide
the bracket forward out of the location tab on the
backside,taking care not to damage wires (fig.31).
Fig. 25
Fig. 26
Fig. 27
Fig. 30
Fig. 31
Mounting
screws
Fig. 29
Fig. 28
Motor