PRELIMINARY
37
SERVICE BULLETIN
FOOT KIT REPAIR – K-14355
Parts Part Number
Rubber feet (12) 14355
Syringe/adhesive (1) 25301
Drywall screw 6 x 2-1/4 (1) 15103
1. Remove the bumper cap.
Note:the rubber foot may be broken or missing.
2. Use a dry wall screw to extract the remaining bumper
material from the grate hole (s).
3. Rotate the screw clockwise to extract the old bumper
stem.
4.Take the cap off the syringe by unscrewing it.
5. Apply a small amount of the adhesive in the grate
hole. Press the new bumper (s) into each of the grate
holes while slightly twisting.
6.Verify that the bumper (s) are fully seated in their
respective holes.
To Next Page
Loading...
